![]() Coordinates of where we can find the options in GPS progranmie ![]() ![]() I do not have to run every time the cloud to hail a GPS signal and be able to simulate such route. Useful for those who are doing something and remove SAVE. Useful for example if somebody falls battery, or suddenly turns off navigation while driving show_oneway = 1 (0) Shows / hides the direction arrows on one-way streets planned_route_contour_width = 8 width of the road at a given route, the default is quite thin refers to the width of the contour set route planned route track width = 5 width of the road at a given route can be wrong, but the greatest value that the program assumes it's probably 5 back_button = 0 (or 1) adds / removes the BACK button in the interface Primo demo_enabled = 0 Hides the DEMO button default_latitude = xx.yyyyyy default_longitude = xx.yyyyyy When you first start igo, or after removing the folder to save the map will open at the location indicated by these has just coordinates. With this option enabled, the navigation is turned off and turn it on again (when navigating), the program will automatically load the last route and will continue to navigate it. shutdown_time = 0 time in seconds for automatic sleep mode when power is removed show_guidance_strip = 1 Shows the maneuver arrow on the map in 2D mode planned_route_visible_behind_mountains = 1 (0) Shows / hides the translucent route, if it covers the terrain (eg, the top) gps_signal_lost = 1, (0) gps_disconnected = 1, (0) Recalculate = 1, (0)Įnable / disable voice informed (by Agatka) the loss of GPS signal, the receiver gps disconnected and the conversion of the route, if we depart from allow_save_route = 1 Enables auto-saving route. show_exit = 1, no entry or 0 - hides the button off 1 - shows it. show_minimize = 1, no entry or 0 - hides the option to minimize, 1 - shows it. Junction_view_blink_time = 1000 (0) lines showing the direction of travel in the JV blink at 1 sec junction_view_blink_time_no_lane = 1000 (0) lines showing the direction of travel in the JV blink at 1 sec set_messages = 0 so that primo correctly shows the status of the satellite (and not 0/0) exit_on_restart = 0 shutdown_time = 0 does not turn off the device when power is removed planned_route_contour_width = 8 width of the road at a given route, the default is quite thin 3dcarsizemin = 10000 3dcarsizemax = 15000 = 25000 3dcarsizemul change the size of the cursor show_mapchanger = 1, no entry or 0 - hides mapchanger 1 - shows it. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
December 2022
Categories |